haier HL22XSLW2 - Manual (Page 7)

Introduction
Haier LED HDTV EN-6
1 PICTURE Press repeatedly to cycle through the available picture modes
2 ARC Select the aspect ratio
3 CCD (closed caption) Select a closed caption option
4 INPUT Show the input source
5 MENU Press to open the on-screen menu
6
Thumbstick (Up/Down/
Left/Right) Volume/Channel Selection, Allows you to navigate the on-screen
menus and adjust the system settings to your preference.
7 EXIT
Clears all on-screen displays and returns to TV viewing from any
menu
8 USB Press to switch input source to USB in
9 USB PLAY/PAUSE
0 USB fast reverse
A USB fast forward
B DISPLAY Press to display the TV status information on the top of the TV screen
C GUIDE Display the guide when you are watching analog or digital channels
D Power Press to turn on and off the TV
E AUDIO Press to cycle through different sound settings
F SLEEP button Press to display the sleep timer option
G MTS/SAP Select MONO, STEREO, SAP in NTSC system
H Number buttons Press to change a channel
I tCVUUPO
Press to select digital channels. For example, to enter “54-3”,
QSFTTiw
itwBOEiw
J MUTE Switches the sound on or off
K ENTER Accesses the highlighted item in the on-screen menu
L RECALL Press to jump back and forth between two channels
M USB REPEAT
N USB STOP
O USB Next Chapter
P USB Previous Chapter
Q CH.LIST Open the channel list in TV
R FAVORITE Open the favourite channel list in TV
(For TV without DVD)
PICTURE
CCD
INPUT
ARC
MENU
VOL-
EXIT
USB PLAY/PAUSE
REV
DISPLAY GUIDE
MTS/SAP
CH+
CH-
VOL+ ENTER
STOP
PREV
FAVORITE
AUDIO
SLEEP
REPEAT
NEXT
CH.LIST
MUTE
RECALL
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
Red
UP DOWN LEFT RIGHT
Green Yellow Blue
Color buttons
When functions are attached to the
color buttons, the color buttons are
shown on screen.
Remote control
The remote control cannot be operated unless the batteries are properly loaded.
When using the remote control, aim it at the remote sensor on the TV.
Precautions
As strong light may interfere the signals, change your
position to operate the remote controller if the television
cannot be turned on or off as you expect.
Keep the remote controller away from heat source
or humid area to ensure effective performance of the
remote controller.
Make sure that two AAA alkaline batteries are loaded.
The batteries must be of the same type. The batteries
must be located properly. The batteries are not
rechargeable.
Make sure that there is no obstacle between the remote
controller and television set.