Hotpoint 22 - Manual (Page 14)

BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT –
Save these
instructions for local inspector’s use.
•
IMPORTANT –
Observe all
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
15 minutes
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
• Do not install the refrigerator where the temperature
will go below 60°F (16°C) because it will not run often
enough to maintain proper temperatures.
• Install it on a floor strong enough to support it fully
loaded.
REFRIGERATOR LOCATION
Installation Refrigerator
Instructions
Models 22 and 25
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
• Sides 1/8 ″ (4 mm)
• Top 1 ″ (25 mm)
• Back 1 ″ (25 mm)
A door clearance of 3/4 ″ (19 mm) is needed for a 90°
door opening which provides better access to the food
storage area.
CLEARANCES
The rollers have 3 purposes:
■
Rollers adjust so the door closes easily when opened
about halfway.
■ Rollers adjust so the refrigerator is firmly positioned on
the floor and does not wobble.
■ Rollers allow you to move the refrigerator away from the
wall for cleaning.
To adjust the rollers, remove the base grille by pulling it
out at the bottom.
Turn the roller adjusting screws clockwise to raise the
refrigerator, counterclockwise to lower it. Use an
adjustable wrench (3/8 ″ hex head bolt) or pliers.
To replace base grille, line up the clips on back of grille
between the bar and the bottom of the cabinet. Push
forward until grille snaps into place.
ROLLERS
If the refrigerator has an icemaker, it will have to be
connected to a cold water line. A GE water supply kit
(containing tubing, shutoff valve, fittings and
instructions) is available at extra cost from your dealer,
by visiting our Website at www.Hotpoint.com (in
Canada, at www.geappliances.ca), or from Parts and
Accessories, 800.626.2002.
WATER SUPPLY TO THE ICEMAKER
(on some models )
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.Hotpoint.com
Questions? In Canada, call 1.800.361.3400 or Visit our Website at: www.geappliances.ca
14