Huffy P/N 21147703 - Manual (Page 9)

03/04 P/N 21147703
9
SECTION A: ASSEMBLE THE POLES
WARNING
LABEL
2
1
3
I.D. Label
I.D. Label
1.
Correctly identify each pole section.
2.
WOOD SCRAP
(NOT SUPPLIED)
2
1
Align dimple of top pole with slot of middle pole. While maintaining alignment, bounce middle pole
(2) into top pole section (1) using a wood scrap as shown until top pole no longer moves toward
pole identification mark on middle pole.
middle pole
IDENTIFICATION
STICKER
middle pole
IDENTIFICATION
STICKER
5"
1-1/2"
POLE
IDENTIFICATION
MARK
THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A 3-1/2"
MINIMUM OVERLAP, LEAVING 1-
1/2" BETWEEN THE OVERLAPPING
POLE AND THE IDENTIFICATION
STICKER.
CAUTION!
POLE SECTIONS
SHOULD HAVE A
3-1/2" (9 CM) MINIMUM
OVERLAP.
NOTE:
1
2
2
1