Harbor Freight Tools 47991 - Manual (Page 4)

Page 4 SKU 47991 for technical questions, please call 1-800-444-3353.
Replacement parts and accessories. When servicing, use only identical replacement
parts. Use of any other parts will void the warranty. Only use accessories intended for
use with this tool. Approved accessories are available from Harbor Freight Tools.
Do not operate tool if under the influence of alcohol or drugs. Read warning labels
on prescriptions to determine if your judgment or reflexes are impaired while taking
drugs. If there is any doubt, do not operate the tool.
use proper size and type extension cord. If an extension cord is required, it must be
of the proper size and type to supply the correct current to the tool without heating up.
Otherwise, the extension cord could melt and catch fire, or cause electrical damage
to the tool. This tool requires use of an extension cord of
0 to 10 amps capability (up
to 50 feet), with wire size rated at 18 Awg. Longer extension cords require larger size
wire. If you are using the tool outdoors, use an extension cord rated for outdoor use
(signified by “WA” on the jacket).
Maintenance. For your safety, maintenance should be performed regularly by a quali-
fied technician.
warning: the warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are factors
which cannot be built into this product, but must be supplied by the operator.
Note: Performance of this tool (if powered by line voltage) may vary depending on variations
in local line voltage. Extension cord usage may also affect tool performance.
uNpAcKINg
When unpacking, check to make sure the parts listed on page 6 are included. If any
parts are missing or broken, please call Harbor Freight Tools at the number on the cover of
this manual as soon as possible.
19.
20.
21.
22.
23.
figure 1
Carbon Brush
(another one on the bottom of the tool)
Chuck
Torque
Switch
Side Handle
Power Cord
Trigger Direction Switch
Lock Button
Note: The Side Handle
fits on either side.
Just unscrew it and
thread it into the
preferred side.