Super Systems 3 Series Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for 3 Series Super Systems
Manuals 
| Recognized languages: | English |
|---|---|
| Pages: | 92 |
| Size: | 1.75 MB |
Show table of contents
Document Outline
- Installation and Basic Operation What Instrument Do I Have?
- 2. Step 2: Wiring
- 2.1 Terminal Layout Series 3 Controller
- 2.2 Wire Sizes
- 2.3 Precautions
- 2.4 Sensor Input (Measuring Input)
- 2.5 Input/Output 1 & Output 2
- 2.6 Remote Setpoint Input
- 2.7 Output 3
- 2.8 Summary of DC Outputs
- 2.9 Output 4 (AA Relay)
- 2.10 General Note About Relays and Inductive Loads
- 2.11 Digital Inputs A & B
- 2.12 Transmitter Power Supply
- 2.13 Digital Communications
- 2.14 Controller Power Supply
- 2.15 Example Heat/Cool Wiring Diagram
- 3. Safety and EMC Information
- 4. Switch On
- 5. Operator Level 2
- 6. Access to Further Parameters
- 7. Controller Block Diagram
- 8. Temperature (or Process) Input
- 9. Input/Output
- 9.1 Input/Output Parameters
- 9.1.1 Input/Output 1 List (IO-1)
- 9.1.2 Remote Digital Setpoint Select and Remote Fail
- 9.1.3 Sense
- 9.1.4 Source
- 9.1.5 Power Fail
- 9.1.6 Example: To Configure IO-1 Relay to Operate on Alarms 1 and 2:
- 9.1.7 Output List 2 (OP-2)
- 9.1.8 Output List 3 (OP-3)
- 9.1.9 AA Relay (AA) (Output 4)
- 9.1.10 Digital Input Parameters
- 9.2 Current Transformer Input Parameters (Current Transformer is not available)
- 9.1 Input/Output Parameters
- 10. Setpoint Generator
- 11. Control
- 11.1 Types of Control
- 11.2 Control Parameters
- 11.3 Tuning
- 11.3.1 Loop Response
- 11.3.2 Initial Settings
- 11.3.3 Automatic Tuning
- 11.3.4 To Start Autotune
- 11.3.5 Autotune from Below SP – Heat/Cool
- 11.3.6 Autotune From Below SP – Heat Only
- 11.3.7 Autotune at Setpoint – Heat/Cool
- 11.3.8 Manual Tuning
- 11.3.9 Manually Setting Relative Cool Gain
- 11.3.10 Manually Setting the Cutback Values
- 11.4 Auto-tune Configures R2G
- 11.5 Example: To Configure Heating and Cooling
- 12. Alarms
- 13. Digital Communications
- 14. Calibration
- 15. Appendix A TECHNICAL SPECIFICATION