Lucent Technologies 9076 Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for 9076 Lucent Technologies
Manuals 
| Recognized languages: | English |
|---|---|
| Pages: | 150 |
| Size: | 1.09 MB |
Show table of contents
Document Outline
- About this Guide
- Introduction to the SP Switch Router Adapter card
- What is the RS/6000 SP Switch Router ?
- SP Switch Router systems for IBM sites
- Upgrading system memory
- Overview of the SP Switch Router Adapter card
- Inserting a media card into the SP Switch Router
- SP Switch Router Adapter card LEDs
- SP Switch Router Adapter card specifications
- Assigning filters
- SNMP on the SP Switch Router Adapter card
- Configuring the SP Switch Router Adapter
- Introduction to installation and configuration
- Installing an SP Switch Router Adapter card
- Installing the PCMCIA spinning disk
- Attaching SP Switch Router cables
- Configuration required on the SP system
- Step-by-step media card configuration
- Step 1. Check SNMP in the SP Switch Router system
- Step 2. Assign IP addresses
- Step 3. Change profile settings
- Step 4. Run dev1config to create grdev1.conf
- Step 5. Reset card to install files
- Verify SP Switch Router Adapter card from router
- Bringing the SP Switch Router Adapter card on-line with the SP
- Monitoring and Management Tools
- SP Switch Router command overview
- SP Switch Router UNIX tools
- Using the netstat command
- Obtaining layer 2 and 3 statistics - grstat
- SP Switch Router Adapter card maint commands
- Preparing to use maint commands
- Sample maint commands
- Find hardware and software version numbers - maint 2
- Find transmit (tx) binary version - maint 102
- Display configuration and status - maint 3
- maint 4 - display media statistics
- maint 5 - display switch statistics
- maint 6 - display combus statistics
- Filtering commands - maint 50-58, 150-58
- List the filters per media card - maint 50
- List where filters are assigned - maint 54
- Configure UDP packet discards - maint 89 7
- Display ARP table - maint 189 1
- Flush the ARP cache - maint 189 10
- Display switch route table - maint 189 2
- “Switch route not found”
- Checking for hardware problems - grdiag
- SP Switch Router dumps
- Data collection utility - grdinfo
- SP Switch Router logs
- Burning in media card flash memory
- Part Numbers
- Log Messages
- Network Configuration Examples
- Upgrading Router Software
- Index