Attachment, Transom angle adjustment – HONDA Outboard Motor BF5A User Manual
Page 22

20
ATTACHMENT
TRANSOM ANGLE
ADJUSTMENT
INSTALLATION
STERN
BRACKET
SAFETY ROPE
CLAMP SCREWS
Attach the stern bracket to the boat
transom by tightening the clamp
screws.
Attach a rope from the boat to the
hole in the stern bracket. This will
help to prevent accidental loss of the
outboard motor.
Use the transom angle adjustment rod
(p.
) to adjust the angle of the
outboard motor so the propeller is
perpendicular to the surface of the
water.
If the outboard motor is installed too
low, the boat will squat and be hard
to plane, and the motor will spray
water that may enter the boat. It will
tend to porpoise, and high-speed
stability will be reduced.
If the outboard motor is installed too
high, that will cause propeller
ventilation.
Optimum installation height varies
with boat type and bottom shape.
Contact the boat manufacturer for
any special recommendations that are
unique to a specific model of boat.
If the transom needs to be modified
to accommodate the outboard motor,
contact the boat manufacturer and
follow their recommendations for
corrective action.
07/01/08 13:05:49 31ZV1630_021