Honeywell DCP552 Mark II - Manual (Page 125)

7-26
End of operation (CH2) 0: READY mode
1: END mode
1 : 5G output (current proportional control output)
2 : 6D output (voltage time proportional control output) system A
3 : 6D output (voltage time proportional control output) system B
4 : 8D output (open collector time proportional control output) system A
5 : 8D output (open collector time proportional control output) system B
[Description:]
The difference between system A and system B is in the
output system of ON-OFF control and auto-tuning.
System A: Output ON-OFF is performed regardless of
time proportional output cycles and output limits.
System B: The output limit upper limit value is output
instead of on and the output limit lower value is output
instead of off according to time proportional output
cycles.
1 C 21 21 Control output system (CH1)
1 C 22 22 Control output system (CH2)
---- C 24 24 Control operation (CH2)
0: PID-A reverse operation
1: PID-A normal operation
2: PID-B reverse operation
3: PID-B normal operation
[Description:]
PID-A: deviation derivative PID (system where SP
changes are affected by derivative action)
PID-B: derivative-based PID (system where SP changes
are not affected by derivative action)
0 C 23 23 Control operation (CH1)
D
+
-
SP
P
I
MV
PV
D
+
-
SP
P
I
MV
PV
Item code Item No.
User
settings
Settings and descriptions
Factory default
settings
---- C 25 25 Unused
---- C 26 26 Unused
---- C 27 27 Unused
---- C 28 28 Unused
---- C 29 29 Unused
0 C 30 30 PV equalizer
[Description:]
Т------У is displayed and setting cannot be performed.
0.0 C 32 32 Manipulated variable in
READY mode (CH1)
0: No
1: PV1 only
2: PV2 only
3: PV1 and PV2
0 C 31 31 End of operation (CH1) 0: READY mode
1: END mode
0 C 33 33 Manipulated variable setting
in PV overrange (CH1)
0: No
1: Yes
0.0 C 34 34 Manipulated variable in PV
overrange (CH1)
Ð5.0 to +105.0 %
0 C 35 35 Manual change mode (CH1) 0: bias
1: preset
0.0 C 36 36 Preset MANUAL value (CH1) Ð5.0 to +105.0 %
0 C 37 37
Manipulated variable in
READY mode (CH2)
-5.0 to +105% 0.0 C 38 38
Ð5.0 to +105.0 %
Chapter 7. PARAMETER SETUP