Solid colored line colored arrow – HoMedics BPA-300 User Manual

Page 8

DATE & TIME SET PROCEDURE
1. To adjust the date/time, press the Set button

located on the back of the monitor.

2. The display will show a blinking number showing

the hour. Change the hour by pressing the
button. Each press will increase the number by one
in a cycling manner. Press the Set button

again

to confirm the entry, and the screen will show a blink-
ing number representing the minutes.

3. Change the time and date as described in Step 2

above, using the

button to change the num-

bers and the Set button

to confirm the entries.

4. A “0” will reappear as the blood pressure monitor is

ready for measurement again.

Press the button

blinking hour

increasing hour

confirm the entry

repeat process to set time and date

USING THE ARM CUFF
Very Important: Proper cuff size is critical to accurate
measurement.

This monitor comes with two sizes of arm cuffs:
Standard Size Fits 9.5"–14.2" (24 cm – 36 cm)
Large Size Fits 13.4"–18.1" (34 cm – 46 cm)

The appropriate cuff is suitable for your use if the
colored arrow falls within the solid color line as shown
below. If the Arrow falls outside of the Solid Color Line, you
need a cuff with another circumference. For circumferences
less than 9.5", contact HoMedics Consumer Relations.

ARROW

MUST

FALL

WITHIN

YELL

BAND

ARROW

MUST

ALL

WITHIN

YELL

BAND

9.5–14.2 Inches

24–36 Centimeters

Standard

Size Cuff Fits:

Center tube over
middle of arm

MODEL# PP-BPCUFF5

Position cuff

edge 0.6˝–1.0˝

(1.5–2.5cm) above elbow.

Center tube over

middle of arm.

Fit cuff securely. Allow room for

two fingers to fit between the cuff

and your arm.

Solid Colored Line

Colored Arrow