HoMedics BPS-060 - Manual (Page 9)

3. Open the arm cuff so that your arm may be placed
through it.
4. Remove tight fitting clothing from around
your upper left arm.
5. Position cuff edge 0.8-1.2
inches (2-3 cm) above elbow.
6. Center tube over middle of arm.
7. Pull the end of the cuff so that it tightens
evenly around your arm. Press the hook
and loop material together to secure.
Allow room for 2 fingers to fit between the
cuff and your arm.
8. Lay your arm on a table (palm upward)
so the cuff is at the same height as your
heart. Make sure the tube is not kinked.
16 15
1. If the cuff is not assembled, pass the end of the
cuff furthest away from the tubing through the metal
D-ring in order to form a loop. The smooth side
without the felt material should be on the inside of
the cuff loop.
2. Plug the cuff tube into the left side of the unit.
Cen ter tube ove r
mid dle ofa rm .
Insert plug here
A R R O W M U S T FA LL
W IT H IN Y E LL O W B A N D
D-ring
End of cuff
Felt Material
on the outside
of cuff