beautypg.com

D-ring end of cuff – HoMedics Automatic Blood Pressure Monitor BPA-201 User Manual

Page 9

background image

15

16

1. If the cuff is not assembled, pass the end of the

cuff furthest away from the tubing through the metal
D-ring in order to form a loop. The smooth side without
the felt material should be on the inside of the cuff loop.

2. Plug the cuff tube into the left side of the unit.

3. Open the arm cuff so that your arm may be placed

through it.

4. Remove tight fitting clothing from your upper left arm so

that the cuff can be wrapped around your exposed arm.

5. Position cuff edge 0.8-1.2

inches (2-3cm) above elbow.

6. Center tube over middle of arm.

7. Pull the end of the cuff so that it tightens

evenly around your arm. Press the hook
and loop material together to secure.
Allow room for 2 fingers to fit between the
cuff and your arm.

8. Lay your arm on a table (palm upward) so the

cuff is at the same height as your heart. Make
sure the tube is not kinked.

ARROW MUST F

ALL

WITHIN YELL

OW BAND

D-ring

End of cuff

2~

3 c

m

(0.8

”~

1.2

”)

Pos

itio

n cu

ff e

dge

0.8

–1.2

inch

es (2

–3cm

)

abo

ve e

lbo

w.

Fit c

uff

Allo

w

to fi

and

Cen

mi

Insert plug here