IK Multimedia iLoud Precision MTM Active 2-Way 175W Dual 5" Studio Monitor (White, Single) - Manual (Page 19)

English
19
It is possible to connect the remote controller to the CONTROL IN port using the supplied TRRS cable, and the
OUT port will then be connected to the IN port of the other speaker to control it: this lets you daisy chain all the
speakers that are included in the system.
6.1 X-Monitor voice control
Once connected to the iLoud Precision monitors for the first time, the remote will automatically sets on position
“1”, selecting the ‘Wide dispersion, quasi linear phase’ precision voice.
By pressing switches 2, 3 or 4 you can switch the X-Monitor voices.
By default, these are the voices assigned to the four switches:
• Button 1: Analytic, linear phase
• Button 2: High End 3-ways
• Button 3: Classic 7 AMT
• Button 4: Studio White
6.2 ARC calibration
When one of the pushbuttons is assigned to the ARC calibration, the remote control will assist you in the
process both if the measurement is launched from the speaker itself with CAL/PRESET button or if it is launched
by the control software.
When the system is in the ARC calibration process, the four buttons on the remote control are actually linked to
the four measurement positions.
Each step of the measurement can be triggered by pressing the corresponding button on the remote control.
Each button’s LED will slowly blink during the phases when the microphone has to be placed at the requested
position, and will fast blink during the measurement of the test signal.
Once the calibration process has completed successfully all four buttons on the remote will flash for 3 seconds.
6.3 Other functionalities
From the control software it is possible to assign other functionalities to the remote control, such as:
- speakers MUTE;
- speakers DIM;
- ARC on/off;