IK Multimedia iLoud Precision MTM Active 2-Way 175W Dual 5" Studio Monitor (White, Single) - Manual (Page 17)

English
17
5) Once the chirps are over, move the microphone to the point 4, and press again the CAL/PRESET button:
3 4
1 2
• after 5 seconds the speaker will emit the calibration test signals (chirps).
IMPORTANT: during the measurement process make sure that the environment is as silent as possible, do not
touch the speaker or the microphone, and make sure that the overall room setup is as similar as possible to the
one that will be used during normal iLoud Precision usage.
Once the last measure has been taken, the system will automatically start calculating the ARC calibration filters.
If the calculation process will conclude without issues, the front LED will blink green for 3 seconds to confirm
the ARC calibration has been successful and that it has been stored: the system will automatically load the
calibration just registered.
... ...
If, for any reason, the calibration ended unsuccessfully, the front LED will blink RED for 3 seconds to show
there has been an error, and the system will automatically exit the CAL procedure. In this case try to repeat the
calibration process.
... ...