Obsidian NETRON DMX10-3 10-Port DMX Splitter with Assignable 3-Pin XLR DMX Outputs - Manual (Page 9)

9
C O N N E C T I O N S
AC CONNECTIONS
The Obsidian Control Systems Netron DMX10 is rated 100-240V 47/63Hz and accept AC
mains power over a range of 90-264V 47/63Hz. Do not connect it to power outside this
range. Damage resulting from incorrect connection is not covered under warranty.
North America: A cable with a NEMA 15-5P plug is provided for use with the DMX10 in the USA and
Canada. This approved cable must be used in North America.
Rest of the world: The provided True1 cable is not fitted with a country-specific plug. Install only a plug
that meets local and or national electrical codes and is suitable for the country’s specific requirements.
A 3-prong grounded-type (earthed type) plug must be installed following the plug
manufacturer’s instructions.
FRONT DMX CONNECTIONS: DMX10-5
- (2) 5Pin DMX Input
- (10) 5Pin Opto-Isolated DMX Outputs
All DMX Output connections are 5pin female XLR; the pin-out on all sockets is pin 1 to shield, pin 2 to
cold (-), and pin 3 to hot (+). Pins 4 and 5 are not used.
Carefully connect DMX cables to the respective ports.
To prevent damaging the DMX ports, provide strain relief and support. Avoid connecting FOH Snakes
to the ports directly.
Pin Connection
1 Com
2 Data -
3 Data +
4 Not connected
5 Not connected
Pin Connection
1 Com
2 Data -
3 Data +
FRONT DMX CONNECTIONS: DMX10-3
- (2) 3Pin DMX Input
- (10) 3Pin Opto-Isolated DMX Outputs
All DMX Output connections are 3pin female XLR; the pin-out on all sockets is pin 1 to shield, pin 2 to
cold (-), and pin 3 to hot (+).
Carefully connect DMX cables to the respective ports.
To prevent damaging the DMX ports, provide strain relief and support. Avoid connecting FOH Snakes
to the ports directly.
REAR CONNECTIONS
- Power In
- Fuse