Oklahoma Sound The Orator, 46" High Built-in Sound Lectern #800x (Mahogany Laminate) - Manual (Page 2)

O KLAHOMA S OUND C ORPORATION ORATOR LECTERN: Model 800 / 800X
7 2
INTRODUCTION
Congratulations! You are now the owner of the Orator,
#800X / #800 Height Adjusting Lectern, from Oklahoma
Sound Corporation. Now also includes wireless options
built in. We wish you long-lasting trouble-free usage for
years to come. If you have any questions or experi-
ence any difficulty with the product, please feel free to
call our Customer Service at 973-594-9000.
IMPORTANT SAFETY INFORMATION
As with any electric/electronic device, care should be
taken during use. Always turn off amplifier before
opening or servicing any part of the unit. Please han-
dle your lectern with the care it deserves.
AMPLIFIER OPERATING INSTRUCTIONS
Operating Precautions
Before operating the amplifier, be sure you fully understand all instructions and fea-
tures of the amplifier. DO NOT turn amplifier on until all input and output connec-
tions have been made. NEVER replace fuses unless power is off.
Microphone Input Connection
The microphone input accepts 1 ⁄4" phone jack. Do not position microphone next to
or facing speakers. This may cause acoustic feedback.
Wireless Operation
Turn on the power on both the wireless receiver and wireless mic-1 making sure
both are set to matching chanels, either “A” or “B”.
Auxiliary Input
One auxiliary input is provided for radio tuner, tape recorder, cd player or multi-
media equipment. Output level is adjusted by the auxiliary volume control.
Tone / Equalization Controls
The Low and High frequency controls are similar to the bass and treble controls
found on most stereo systems. Optimum tone is achieved by first setting both knobs
halfway; adjust Low and High frequency controls to suit environment.
Auxiliary / Line Out
Connect speaker line to navy line out connector of the amplifier. For maximum
power transfer and to avoid amplifier overload, be sure that the total impedance
of the speaker line matches the output impedance setting on amplifier.
Be sure
that speaker terminals are not shorted together by speaker line connecting
cables. Can also be used for a recording device.
Power Supply 12V DC Operation
Connect a 12 volt rechargeable battery 5 Amp (not included) to the battery input
connector located on the panel of the amplifier (using 6' battery cable). Be sure
that the positive pole of battery is connected to the white wire terminal (+) and
the negative pole to the Brass wire (–). When lectern is plugged into a standard
wall outlet, the battery will automatically recharge. Green indicator light illuminates
during recharge mode.
Precautions
• Set Mic volume control on lowest when turning unit on.
• Insure correct polarity for D.C. supply connections.
• Reverse connection will blow the fuse and may damage internal circuitry.
• Always replace fuse with specified rating.
Removal and Installation of Amplifier
If your amplifier has to be removed for servicing — follow these simple steps:
1) Disconnect A/C wall plug.
2) Remove 2 side screws one on each side panel under podium top. Model 800
owners, simply loosen height adjustment knob and remove top.
3) Disconnect speaker wire at rear of amplifier card.
4) Remove 4 wood screws holding chassis to podium and remove amplifier.
5) Pack it into a strong box with ample cushioning and return to factory.
6) To install new amplifier reverse the above procedure.
MANUFACTURER’S WARRANTY
Our Lecterns undergo the most rigid and exacting tests for superior quality
and performance before leaving the factory. Oklahoma Sound Corporation
warrants this product to be free from defective material and workmanship on
the electronic product speakers and microphones for two years from the date of
resale by an authorized Oklahoma Sound distributor. Oklahoma Sound will
replace defective parts and repair malfunctioning products under this war-
ranty when the defect occurs under normal installation and use, provided the
unit is returned to our factory via prepaid transportation after direct autho-
rization and approval by Oklahoma Sound. This warranty provides that
examination of the returned product must disclose in our judgement, a man-
ufacturing defect. This warranty does not extend to any product which has
been subject to misuse, neglect, accident, improper installation, or where the
serial number has been removed or defected and is given in lieu of any other
warranty implied or expressed and will not cover any consequential damages.