Bose Professional FreeSpace FS2P 2.25" 20W Passive Pendant-Mount Loudspeaker (Pair, Black) - Manual (Page 4)

4 • English FreeSpace FS2P • Installation Guide
PRO.BOSE.COM Setup
Wiring the Loudspeaker
Wire Gauge
The FreeSpace FS2P loudspeaker is designed to work with 18 AWG (0.8 mm 2 ) to 14 AWG (2.1 mm 2 ) size wire only.
Loudspeaker Settings
70V
1W 2W 4W 8W 16W*
16Ώ
2W 4W 8W 16W NC**
100V
** NC: No Connection (do not use) * Factory default
Transformer Tap Setting
Set tap by turning. Use a flat head screwdriver.
Connection Diagrams
Expose six millimeters (1/4 inch) of
bare wire to attach to the terminals.
Note: The loudspeaker is not rated
for use with a rigid conduit. The
loudspeaker is suitable for a flexible
conduit or wiring connection only.
Note: Wiring method must be in
accordance with:
In Canada, CSA C22.1, Canadian
Electrical Code, Part I, Safety
Standard for Electrical Installations,
Section 32;
In the United States, The National
Electrical Code, NFPA 70, and the
National Fire Alarm and Signaling
Code, NFPA 72.
70/100V 16Ω
Preparing the Input Cover
The input cover is designed for three different wiring scenarios. To change the configuration of the
input cover to support your wiring scenario, cut along the perforation on the rubber conduit. Use one
1/2-inch to 1/2-inch threaded coupling and two 3/8-inch trade size conduit fittings for 1/2-inch knockouts
(see diagram to the right).
CAUTION: Do not use the wide open wiring scenario when installing the input cover with a
flexible conduit.
Note: It is the installer's responsibility to seal against water ingress into the Euroblock connector. Use
outdoor or marine-grade silicone to seal all wiring connections to ensure a tight seal.
Note: Flexible conduits and couplings must be UL Listed, suitable for the application, and installed in
accordance with the local authorities having jurisdiction.
Single In In and Out Wide Open
16Ω 16Ω 16Ω 16Ω