BenQ RM8602K 86" Class 4K UHD Educational Touchscreen LED Display - Manual (Page 19)

Connection 19
Connection
Connecting the VGA input
1. Connect the VGA jack on the display to the VGA output jack on a computer using a
D-Sub (15-pin) cable.
2. Connect the computer’s audio output jack to the AUDIO IN / MIC IN jack on the
display with a suitable audio cable.
Connecting the touch module
Connect the TOUCH (type B) jack on the display to the USB port of a computer using
the supplied USB cable. The touch module of the display supports easy Plug-and-Play
operation. There is no need to install additional drivers on the computer.
• Avoid blocking the touch screen frame (where sensors are located) when initiating the touch
module.
• It is highly recommended that you connect the display to the PC or laptop directly. Avoid
connecting the display to a face plate device which may cause failures in touch operations.
• If any ghost image occurs, please try to un-plug and then re-plug all USB cables. If the failure
image still exists, use another USB type B to A cable.
• TOUCH 2 port must be connected with HDMI IN 3 or VGA .
D-Sub (15-pin)
cable Audio
cable
HDMI
cable
USB cable
Computer