Panasonic TH-86EQ2W 85.6" 4K Digital Signage Display - Manual (Page 55)

55
English
Power on settings
Makes various settings at power-on.
[Power on settings] - submenu screen
0
Power on settings
Initial input
Initial startup
Initial VOL function
Initial VOL level
Information(Power management)
Power ON screen delay
Information(No activity power off)
Off
Last memory
Off
Off
Off
Off
Information(Colour design) Off
Quick start Off
■
[Initial input]
Sets the input at power-on.
[Off] / [HDMI1] / [HDMI2] / [HDMI3] / [USB-C] /
[SLOT] / [PC] / [PC [YP
B
P
R
]] / [Screen Transfer]
/ [USB/Internal Memory] / [ MEMORY VIEWER ] /
[WHITEBOARD]
Note
● When [Input lock] is set to the item other than [Off],
this menu will be greyed out and cannot be set. (see
page 67)
■
[Initial startup]
Sets the power status of the main unit when the
power plug is inserted/extracted, or when the power
is restored from instantaneous interruption due to
blackout, etc.
[Last memory]:
Restored to the state before the power is turned
off.
[On]:
Restored to the power-on state. (power indicator:
blue)
[Standby]:
Restored to the standby state. (power indicator:
orange / purple)
Note
● When multiple units are installed, it is recommended
to select [Standby] to reduce the load when the power
is restored.
■
[ Initial VOL function ]
Enables/Disables the volume setting function at
power-on.
[Off]:
Volume before power-off
[On]:
Volume set for [Initial VOL level]
■
[ Initial VOL level ]
Sets the sound volume when [Initial VOL function] is
enabled.
Note
● The sound is output with the set volume when [Initial
VOL function] on the menu is in [On] state.
● When [Maximum VOL function] is set to [On], the
volume cannot be set to the level higher than the level
set for [Maximum VOL level].
■
[Power ON screen delay]
When multiple displays are installed and are turned
on simultaneously, this function distributes the load
of power by delaying the power supply timing of each
display. Setting is required for each display.
[Off]:
The powers are supplied at the same time as
power-on.
[Auto]:
The delay time is automatically set according to the
numbers set for display IDs.
The delay time is determined by multiplying a
display ID by 0.3 seconds.
Example: If the display ID is 3, the delay time is 0.9
seconds.
1 - 30:
Sets the delay time (sec.). The powers are
supplied to the display with the set time of delay
after power-on.
Note
● The power indicators blink blue from start to end of
the delay operation process.
● This function also works when the power plug is
inserted/extracted, or when the power is restored
from instantaneous interruption due to blackout, etc.
■
[Information(No activity power off)]
Sets the display/non-display of the no-activity-auto-
power-off warning message when the power is turned
on.
[On]:
The warning message is displayed when the power
is turned on.
[Off]:
The warning message is not displayed when the
power is turned on.
Note
● This setting is enabled when [No activity power off] is
[Enable]. (see page 67)
■
[Information(Power management)]
Sets the display/non-display of a message that
tells the power has been turned off by the power
management function when the power is turned on.
[On]:
The message is displayed when the power is
turned on.
[Off]:
The message is not displayed when the power is
turned on.
Note
● This setting is enabled when “Power management”
function is [On]. (see page 61)