Suprema XPass D2 Outdoor Compact RFID Reader - Manual (Page 11)

Installation
11
Wiegand and other cable connections
Restoring the Factory Defaults
This will reset all settings stored on the device.
1 Turn the power on.
2 Press the reset button three times quickly.
3 When the yellow LED is blinking, press the reset button again.
Resetting the baud rate of RS-485
1 Turn the power on.
2 Press and hold the reset button for more than 2 seconds. When the device change to setup mode, the yellow LED is blinking.
3 Depending on the number of times the reset button was pressed, the baud rate changes. You can recognize the baud rate
according to the LED color.
The number of times Baud Rate LED Color
1 9600 Cyan
2 19200 Blue
3 38400 Magenta
4 57600 White
5 115200 Red
4 The LED blinks for 5 seconds with the color set as the above. The baud rate is set once you hear a beep sound.
NOTE
• If you do not press the reset button after changing to the setup mode, the baud rate is set to 115200.
1 - PWR +VDC Red
2 - GND Black (White stripe)
5 - WG D0 Green
6 - WG D1 White
7 - LED RED Orange
8 - LED GRN Brown
9 - BEEP Purple
10 - TMPR Gray
Control device
XPass D2
DC power