Godox V1 Flash for and Panasonic - Manual (Page 13)

To set the bounce direction, hold the flash head and turn it to a
satisfying angle.
By pointing the flash head toward a wall or ceiling, the flash will
bounce off the surface before illuminating the subject. This can
soften shadows behind the subject for a more natural-looking shot.
This is called bounce flash.
Bounce Flash
● If the wall or ceiling is too far away, the bounced flash might
be too weak and result in underexposure.
● The wall or ceiling should be a plain, white color for high
reflectance. If the bounce surface is not white, a color cast
may appear in the picture.
In Manual Zoom mode, press the
button.
● Turn the Select Dial to change
the flash coverage.
● If < > is displayed, the flash
coverage will be set
automatically.
If you set the flash coverage manually, make sure it covers
the lens focal length so that the picture will not have a dark
periphery.
Low Battery Warning
If the battery power is low, < >
will appear and blink on the LCD
panel. Please replace the battery
immediately.
-7-120 °
330 °
C.Fn: Setting Custom Functions
The following table lists the available and unavailable custom
functions of this flash.
m/ft
BEEP
LIGHT
LCD
ID
m
ft
ON
OFF
12sec
OFF
ON
-3~+3
OFF
01-99
Distance indicator
Beeper
Backlighting time
LCD contrast ratio
Wireless ID
C . Fn Custom Functions
Custom
Function
Signs Function Setting
No .
Settings &
Description
m
feet
ZOOM 4/3
135
Zoom display 4/3 Sytem
135 System
Sv STBY 60min
30min
Slave auto power
off timer
60min
30min
ON
OFF
Off in 12 sec.
Always off
Always lighting
7 levels
Off
Choose any figure
from 01-99
1. Press < MENU> Button until C.Fn menu is displayed. The “Ver
x.x” in the top-right corner refers to the software version.
● Turn the Select Dial to select the Custom Function No.
3. Change the Setting.
● Turn the Select Dial to set the desired number. Pressing Set
Button will confirm the settings .
2. Select the Custom Function No.
4. In the C.Fn states, long press the “Clear”button for 2 seconds
until “OK”is displayed on the panel, which means the values in
C.Fn can be reset.
● After you set the Custom Function and press < MENU > button,
the camera will be ready to shoot.
● Press Set Button and the Setting No . is selected.
STBY ON
OFF
Auto sleep setting ON
OFF
SCAN OFF
START
Scan the spare
channel
OFF
Start to find the spare
channel
CH 01-32 Channel setting
Choose channels
from 01-32
- 51 - - 52 -
The flash coverage can be set automatically or manually. It can be
set to match the lens focal length from 12 to 52mm(43 format) or
24mm to 105mm(135 format). Also, with the built-in wide panel, the
flash coverage can be expanded for 7mm(43 format) or 14mm (135
format) wide-angle lenses.
ZOOM: Setting the Flash Coverage and Using
the Wide Panel