Godox V1 Flash for Sony - Manual (Page 12)

This describes wireless (multiple shooting) using manual flash. You
can shoot with a different flash output setting for each slave unit
(firing group). Set all parameters on the master unit.
7. M: Wireless Flash Shooting with Manual Flash
Setting the flash mode to 1
.
Taking the picture. 3
Setting Flash Mode
You can directly operate the slave unit to manually set the manual
flash or stroboscopic flash.
Setting the slave unit. 1
that < M > is displayed.
Setting flash mode to . 2
● Press < MODE > button so
● Set the manual flash
output. (Page 41)
< >. Turn the Select
Dial to set the flash output
of the groups. Press Set
Button to confirm.
Setting flash 2
output.1/2/3/4
● Press Function Button 3
Gr
● Each group fires at the set
flash ratio.
8 . Multi: Wireless Flash Shooting with Manual Flash
Setting stroboscopic
flash.
● Setting the stroboscopic flash.
(Page 42)
● Press < MODE > button so that
< MULTI > is displayed.
SONY
CH 21
Other Applications
Sync Triggering
The Sync Cord Jack is a Φ2.5mm plug. Insert a trigger plug here
and the flash will be fired synchronously with the camera shutter.
Auto Focus Assist Beam
In poorly-lit or low-contrast shooting environments, the built-in auto
focus assist beam will automatically light on to make it easier for
autofocus. The beam will light up only when autofocus is difficult
and get out as soon as the autofocus becomes correct.
If you want to turn off the auto focus assist beam, set the “AF” to
“OFF” on the C.Fn settings.
● Camera models that support auto focus assist beam:
α7M3/α7R3/α7II/α7/α6000/α9
● If you find the auto focus assist beam does not light up, this
is because the camera has got a correct autofocus.
Position
Center
Periphery
Effective Range
0.6~10m / 2.0~32.8 feet
0.6~5m / 2.0~16.4 feet
- 49 - - 50 -