Angler Mini CatchLight Reflector V2 (18 x 37") - Manual (Page 4)

4
Assembling the Mini
CatchLight
1. Loosen the bracket’s locking knob
and place it on a light stand’s 5/8-
inch stud. Tighten the locking knob
until secure.
2. Thread the main tubes through the
sleeves on the top and bottom of the
reflector. Important! The holes on
the ends of the main tubes must be
facing each other.
3. Slide one of the vertical rods through
the unzippered sleeve, and fit its ends
into the holes at the end of the main
tubes.
4. Partially unzip the zippered end
of the sleeve, and slide the other
vertical rod through. Fit the ends
into the holes at the end of the main
tubes, and zip up the sleeve to pull the
reflector fabric tight.
5. Align the bracket’s bolts with the
mounting holes in the center of the
two main tubes, and fit the reflector
onto the bracket. Secure it with the
attachment knobs.
1
2
3
4
5