Profoto B1X 500 AirTTL 1-Light To-Go Kit - Manual (Page 10)

B1X
10
www.profoto.com
Operation
Quick guide
For detailed operating instructions, see subsequent sections.
1. Charge the battery (see page 17).
2. Mount the battery (see page 17).
3. Remove the transport cap from the Reflector/Front glass [5].
4. Fit the Stand adapter [3] to a light stand and secure it with the
Clamp screw [4] (see page 18).
5. Adjust the tilt position of the flash by loosening the Tilt-lock knob
[2] (see page 18).
6. Switch on the unit by pressing and holding the TEST button [15]
(see page 11).
7. Select Freeze/Normal mode by pressing and holding the
ENERGY/SETTINGS dial [16] and then shortly pressing the TEST
button [15] (see page 11).
8. Select flash light output with ENERGY/SETTINGS dial [16] (see
page 12).
9. Release a test flash by pressing the TEST button [15].
10. Select Sync setting [21] with the SYNC button [18] (see page 13).
11. Select Modeling light setting [19] with the MODEL button [14] (see
page 15).
12. Select Ready signal setting [20] with the READY button [17] (see
page 15).
13. Mount Light Shaping Tools (see page 18).