beautypg.com

Interfit Honey Badger 320Ws Compact Flash Head User Manual

Page 8

background image

Setting Groups

**Setting the control channel is only necessary when using the Interfit remotes. If you are using a third-party radio

system or optical slave, you can skip this section. When using an Interfit TTL remote, only groups A-C are available.

Setting the control group allows you to independently control the power of each light in your studio without

affecting your other lights. Your Honey Badger can be set to eight different control groups (A-H). Press the

GROUP button to assign your light to it’s own group.

Beep Button

Press the BEEP button to turn off the audible sound for buttons, power adjustments and refresh notifications.

**When using an Interfit remote, the beep will sound if you attempt to lower the power below 4.0, regardless of

whether the beep function has been turned off or not.

Optical Slave Cell

When using a multiple light setup with your Honey Badger and a sync cord or a third-party remote, turn on the

CELL button to activate the optical slave function. This will allow the light to be triggered by the light of your

other flashes. NOTE: This requires direct line of sight between lights.

Mount to a Light Stand

Your Honey Badger 320 will mount to most standard light stands with a 5/8” stud. Unscrew the Stand Mount

Tightening Knob until the mount fits onto the light stand. Make sure to turn the mount tightening knob until tight.

Use the Ratcheting Adjustment handle to adjust the angle of the light on the stand. The resistance of the

Ratcheting Adjustment handle provides extra security when using large, heavy modifiers.

Interfit 24” (60cm) Pop-Up Softbox

Take your softbox out of it’s zipper pouch and let it unfold. Attach the hooks of the inner diffuser to the elastic

loops on the inside of the softbox. Attach the outer diffuser to the Velcro around the outside of the softbox.

Mounting: Opening of softbox will fit tight around the outside of the mount ring. Stretch each side around and

the soft box will stay attached by tension.

Replacing the Flash Tube and Frosted Glass Dome

Both the flash tube and frosted glass dome are user

replaceable. Replacement parts can be purchased through

Interfit Photographic or a certified Interfit dealer.

*

The oil from your fingers will damage flash tubes. Be

sure to handle new flash tubes with gloves or clean

cloth. Always use caution when handling broken glass.

www.interfitphotographic.com 7

BEEP

CELL

GROUP

This manual is related to the following products: