Interfit Honey Badger 320Ws Compact Flash Head - Manual (Page 7)

Using Your Honey Badger
Powering Up Your Honey Badger
Plug in the 13’ power cable included with your Honey Badger kit to the back of the unit and plug into a 110V/
60Hz (220V/50Hz) grounded power outlet. Activate power with the ON/OFF switch on the back control panel of
the flash head.
Using the Test Function
The Test button will illuminate red when the flash is charged and ready for use. The red indicator light will turn off
immediately after the flash has fired, and turn on again once the light has full recycled. Recycle is also indicated
by an audible beep when the Beep function is enabled.
Adjusting the Power
Your Honey Badger is packed with 320Ws of power. This power is adjustable over a 7-stop range and can be
adjusted in 1/10th of a stop intervals. Use the + and - buttons on the back of your Honey Badger to adjust the
power from 10.0 (full power) to 4.0 (lowest power). Power is displayed on the LCD screen.
Turn off the Flash Function
To take advantage of your modeling lamp function without triggering the flash, press the FLASH button. This will
turn on and off the flash function of the light, but keep the modeling lamp function available. This function is
ideal when using the LED modeling lamp of one Honey Badger to light your subject, and mixing it with the flash
of another Honey Badger.
Using the Modeling Lamp
To use the 60w LED modeling lamp, press the MODEL button on the back interface of the Honey Badger to
toggle through two different modeling lamp modes or turn it off.
Proportional mode- Toggle the modeling lamp mode to PROP. When used in proportional mode, the
intensity of the modeling lamp will increase and decrease according to the flash power. This is useful when
creating lighting ratios with multiple lights. Use the + and - buttons to adjust the modeling lamp brightness even
when flash is turned off.
Full mode- Toggle the modeling lamp mode to FULL. This will turn the modeling lamp on to full power.
Setting Channels
**Setting the control channel is only necessary when using the Interfit remotes. If you are using a third-party radio
system or optical slave, you can skip this section. When using an Interfit TTL remote, only channels 1-8 are available.
Having 15 unique radio control channels allows you to use your lights in close proximity with another
photographer without interfering with one another. Press the CHANNEL button to toggle through the 15
available isolated control channels. Make sure the channel selected on your Honey Badger matches the selected
channel on your Interfit remote.
www.interfitphotographic.com 6
FLASH
MODEL
CHAN
+
_
TEST