Planar Systems PLN2700 27" Monitor - Manual (Page 12)

10
Quick Installation
1. Connect either HDMI or VGA Video Source from the monitor to the computer. Make
sure both monitor and computer are powered OFF. Please note the monitor ships with
an HDMI cable only.
2. Connect the power cord to a properly grounded AC outlet, then to the monitor.
3. Power-ON computer and then POWER-ON the monitor.
4. Set the timing mode on your computer. Recommended resolution and refresh rate is
1920x 1080@60Hz.
Figure 1:
Power Cord
VGA cable (not included)
HDMI cable