Instruction manual, Oop pe erra attiio on n – StarTech.com 4-Port DVI USB KVM Switch with Audio and USB 2.0 Hub (Black) User Manual
Page 7
Instruction Manual
4
1
.
Online/Selected LEDs
When the LED turns green, the computer connected to the corresponding port
is powered-on. When a computer is selected, its corresponding red LED
illuminates.
2
.
Pushbuttons
Each computer has a button associated with it on the front panel for selection.
For example, to switch to computer 2, press the 2 button.
Auto Scan
Auto Scan automatically scans through computers one at a time, in a fixed interval.
Please note
: keyboard and mouse are not operable during Auto Scan. To activate Auto
Scan, press down front panel push buttons
3
and
4
simultaneously. The port LED
flashes during Auto Scan. Auto Scan is effective for powered-on computers only. To exit
the Auto Scan mode, just tap any one of the front panel pushbuttons.
Scan Time
This selection sets the scan interval for the Auto Scan feature. The Scan Time options
are 3, 8, 15 and 30 seconds.
Please note
: Scan Time is automatically set to a default of
3 seconds, in the event that SV431DVIUA loses power. To change the Scan Time
interval, press both front panel buttons 1 and 2 simultaneously. SV431DVIUA will beep
1
,
2
,
3
or
4
times for scan time of
3
,
8
,
15
or
30
seconds respectively.
O
Op
pe
erra
attiio
on
n
SV431DVIUA Front Panel
1
2
Please note:
SV431DVIUA can be used with a VGA connection to controlled
(slave) computers, however an adapter must be used to make the connection
(please see
Accessory Products from StarTech.com
- DVIVGAMF).
Also note:
Analog and digital connections cannot be used concurrently. To
successfully connect SV431DVIUA to the slave computers, all connections
must be either digital
or analog.