GRAM FS 3125-90/1 - Manual (Page 10)

EN
User guide
4. The appliance should be positioned on a level
surface. The two front feet can be adjusted as
required.To ensure that your appliance is
standing upright adjust the two front feet by
turning them either clockwise or anti-clockwise,
until firm contact is secured with the floor.
Correct adjustment of the feet prevents
excessive vibration and noise
(Fig. 4).
5. Refer to the "Cleaning and Care" section to
prepare your appliance for use.
6. If you want to place two products side by
side, e.g. a refrigerator and a freezer, as a side
by side solution you have to use a decoration kit
which contains a small mat and a decoration
part. The mat is mounted on the side of one of
the products to create a space between the
products. The decoration part is placed between
the products to hide the gap between the
products
(Fig. 2) . The decoration kit is not a part
of the product but can be delivered as an
accessory.
Temperature control and adjustment
The freezer temperature is influenced by the
thermostat control
(The recommended
positions are either 2 or 3) (Fig. 5).
In general, this temperature is below -18°C. Lower
temperatures can be obtained by adjusting the
thermostat control towards the position MAX.
We recommend checking the temperature with
a thermometer to ensure that the storage
compartments are kept to the desired
temperature. Remember to read off the
thermometer immediately as the temperature on
the thermometer will rise very rapidly after you
remove it from the freezer.
Please remember that each time the door is
opened cold air escapes and the internal
temperature rises. Therefore never leave the
door open and ensure that it is closed
immediately after the food is put in or removed.
Before operating
Final Check
Before you start using the freezer check that:
1. The legs have been adjusted for perfect
levelling.
2. The interior is dry and that air can circulate
freely at the back of the appliance.
3. The interior is cleaned as recommended
under the section "Cleaning and care".
4. The plug is inserted into the socket and the
electricity supply is switched on. Avoid
unintentional disconnection by placing sticky
tape on the switch.
And note that:
5. You will hear a noise as the compressor
starts up. The liquid and gases sealed within
the refrigeration system may also make some
noise, whether the compressor is running or
not. This is quite normal.
6. To freeze the fresh food use the
compartment marked with 4 stars.
7. Do not put a too large quantity of food into
the freezer. The food quality is kept if it is
frozen as quick as possible. Therefore it is
preferable not to exceed the freezing capacity
of the appliance shown in the "Technical data"
section. The thermostat knob shall be
adjusted in order to obtain the lowest
temperature inside the freezer, with the fast
freeze function activated and the orange lamp
lighting.
8. Do not load the appliance immediately
after it has been switched on. Wait until the
correct storage temperature has been
reached. We recommend that you check the
temperature with an accurate thermometer
(See
the ”Temperature Control and
Adjustment
” section).
9. Remember to remove all packing materials
- including transportation security in the form
of tape, styrofoam, cardboard, etc. within the
enclosure. It is also important to remove any
styrofoam / cardboard in the evaporator tray
on the back of the closet, otherwise there is a
risk that water is leaking on the floor.
Important Note:
In the event of an electrical cut do not open
the door. Frozen food should not be affected if
the it lasts for less than 18 hours. If the
electrical cut lasts longer than 18 hours, then
the food should be checked.
3