Mpman XRM7 - Manual (Page 7)

INSTALL THE REMOTE CONTROL BATTERY
1. Remove the battery door.
2. Install 2pc ``AAA`` battery into the battery bracket (batteries not provided). Make sure that the +
symbol is respected
3. Close the battery door.
Note:
1. Battery chemicals can cause a rash. If the batteries leak, clean the battery compartment with a
cloth. If chemicals touch you skin, wash immediately.
2. If the remote control is not going to be used for an extended period of time, remove the batteries.
3. Dispose of used battery by following your local hazardous waste regulations.
SYSTEM CONNECTION
You can connect the player to the speakers and enjoy listening.
Connect the speaker cables to the SPEAKER jacks which on the back of the player.
BASIC OPERATION
PREPARATIVE
1). Before turning on, check whether all the connection are correct and reliable. Plug the power
cord at last.
2). Press POWER button on the front panel to turn on.
3). Press EJECT button on the front panel to open the disc door, put the disc into the CD
compartment, and then close the disc door. The unit starts reading and playing.
POWER
Press the POWER button on the remote control (or front panel) to turn on or back to standby mode
NUMBER BUTTONS
While playing songs, press the NUMBER buttons on the remote control to select the songs
you need. For example, the second song is required: press the 0 and 2 buttons. If the 16
th
song is need, press the 1 and 6 buttons.
VOLUME ADJUSTMENT
Press the VOL-/+ buttons on the remote control to turn up or down the volume of this unit.
You can also turn the VOLUME KNOB on the front panel to control volume.
PLAY/PAUSE
In play status, press the PLAY/PAUSE button, the play will be paused, and press it again to
continue playing.
STOP
While playing CD disc, press the STOP button on the remote control, and then press
PLAY/PAUSE button, the disc will be played from the beginning.
7