Mpman XRM7 - Manual (Page 10)

select the 15th band. Press the CH- or CH+ button, the band will be switched up or down.
3) Automatically search bands: press the AUTO button, this unit will start to search bands from the
lowest part to highest part automatically. Meanwhile the searched bands will be saved orderly.
Press the button again to stop searching.
3. Soundtrack Selection
Press the MO/ST button on the remote control, you may select Mono and Stereo soundtrack output
in FM status. If the signal is not strong enough, you cannot select Stereo.
4. Exit FM Status
Press the CD/FM button on the remote control (or front panel) to exit FM status, and press
CD/USB switch to other modes.
Remark: FM Frequency range: 87.5-108 MHz
NOTE: 1. You may adjust the best radio effect by adjusting the antenna.
2. You can search further bands by pressing AUTO button when adjusted the antenna in a right
position.
3. If the band is not clear by auto search, you choose the way manual search adjustment by
press SEEK-/SEEK+ button.
4. The channel number could not exceed 20
5. Cannot input the frequency number directly.
SPECIFICATION
Output ports L/R speaker output ports
Input ports USB In, Headphone Jack
Power supply 230V~ 50Hz
Max power 30W
Frequency 20Hz-20KHz ±3dB
TROUBLE SHOOTING
Please use the following methods to solve the following problems while using this unit.
Fault Phenomenon Possible Cause Handing
Power supply cannot be
turned on
Power plug is not fully inserted into
the socket
Insert the power plug into
the socket securely
Battery is used up
Replace with a new
battery
The remote control does
not work
The front end of the remote control
is not aimed at the infrared
reception part of the player
Please aim at the remote
control window
The disc door is not close well Close the disc door
No disc inserted
Place a disc in the
compartment
Play can not be realized
Inverse placement of disc
Be sure that the side with
pictures of the disc points
upwards
10