Silvercrest SHBS 3.7 A1 - Manual (Page 81)

79 GB
6.4 Trimming a beard
Beard trimmer attachment13
NOTE: please note that the cutting lengths will only be
achieved if the switch for cutting length fine tuning6 is at po-
sition 1 and the hair and beard trimmer5 is held at a right an-
gle to the skin surface.
• Comb the beard in the direction that it grows.
• Trim the beard downwards from ear to chin. First trim one
side, then the other.
• Comb attachment1
Figure C: adjust the cutting length with the slider accord-
ing to the desired hair length and read off the cutting
length using the marking on the side of the comb attach-
ment1 (3, 4, 5, 6 mm). Now, shorten your beard step-by-
step.
• Use the beard trimmer attachment13 without a comb at-
tachment1, to cut the beard very short or to cut a mous-
tache and hairline.
• Using the switch for cutting length fine tuning6 the cutting
length can be slightly varied with three levels (1: 0.8 mm /
2: 1.3 mm / 3: 1.8 mm).
• To trim your moustache, first comb it straight downwards.
Then use either the beard trimmer attachment13 or the
precision trimmer attachment4. Start at the centre above
the mouth and trim first one side, then the other.
BB.5$B%ERRN6HLWH0LWWZRFK'H]HPEHU