Silvercrest SHBS 3.7 A1 - Manual (Page 79)

77 GB
6.1 Changing the cutting attachments
WARNING! Risk of injury!
Switch off the hair and beard trimmer5, before you attach or
remove the attachments.
• Figure A: to remove the attachments12,3,4,11,13
use your thumbs to press the attachment towards the rear
of the hair and beard trimmer5.
• Figure B: to attach the attachments, put the lower flap of
the attachment12,3,4,11,13 into the slot in the hair
and beard trimmer5 and press the upper part of the at-
tachment against the hair and beard trimmer until it audi-
bly locks into place and sits firmly in position.
6.2 Changing the comb attachments
Pushing on
• To attach the comb attachments2 +1 carefully slide the
appropriate comb attachment over the hair or beard trim-
mer attachment12 /13. Press the lower part of the comb
attachments2 firmly until they lock into place.
Removing
• To remove the comb attachments2 loosen the comb at-
tachment at its lower end and pull it off the hair and beard
trimmer5.
• Slide the comb attachment1 for the beard trimmer attach-
ment13 upwards from the hair and beard trimmer5.
BB.5$B%ERRN6HLWH0LWWZRFK'H]HPEHU