Silvercrest SHBS 1000 A1 - Manual (Page 79)

79 GB/MT
Q
Cleaning the housing
Clean the housing using a slightly moist cloth.
Q
Cleaning your hair and beard clippers
Switch off the hair and beard clippers by pressing the ON / OFF
switch
3 .
Disconnect the lead from the device and pull the plug-in mains
adapter out of the mains socket.
Take any fitted cutting length comb attachment 6 off the device.
Wash the cutting length comb attachments 6 when necessary by
holding them under flowing water.
Then fully dry the attachments.
Using your thumb from the front of the device, press against the
teeth of the cutter head to release the blade set
1 from its mount
(see Fig. B).
Use the supplied cleaning brush to remove any remaining hair
residue from the blade set
1 .
After cleaning, place the locating lug of the blade set 1 back
into the locating hole of the cutter head mount (see Fig. C).
Re-engage the blade set 1 by applying a little light pressure from
the rear of the device (see Fig. D).
Tip: To reduce friction apply one or two drops of cutter oil (accessory)
from time to time between the blades and spread it out evenly. You
may also use any acid-free oil (such as sewing machine oil). Wipe
away any excess oil with a cloth.
Cleaning and care Use / Cleaning and care