Silvercrest SHBS 600 A1 - Manual (Page 54)

52 GB
5. Operation
Regardless of the charging state of the batteries, you are always able to use the
hair and beard trimmer with the power pack.
1. In order to use the power pack, ensure that the device is switched off.
2. Connect the power unit to the connector7 of the device.
3. Insert the power unit into a readily accessible wall socket whose voltage
matches the voltage stated on the rating plate.
4. Switch on the device with the on/off switch5.
5.1 Pushing on/removing the comb attachments
WARNING! Risk of injury!
Switch off the device before replacing or changing the comb attachments.
Pushing on
• In order to attach a comb attachment, push this over the guide rails on the
side of the device onto the comb attachment fastener4, until it is heard to
click into place.
Removing
1. Figure A: to change the comb attachments, turn the device onto its back.
2. Figures B/C: push the comb attachment1 upwards together with the slid-
er10. Push the comb attachment carefully upwards with moderate force us-
ing your thumb and index finger beyond the side locking pins. The comb
attachment is released from the comb attachment fastener4.
3. Remove the comb attachment.
5.2 Cutting hair
NOTES:
•
The hair to be dressed must be dry.
• The cutting length may deviate depending on the cutting angle.
• Place a sheet or cape around throat and neck to prevent cut-off hair from
dropping into the collar.
• Comb the hair well.
__GRA78917_B2.book Seite 52 Donnerstag, 6. September 2012 7:53 07