Silvercrest SHBS 600 A1 - Manual (Page 55)

52 SHBS 600 A1
GB
MT
Cleaning and care
DANGER
Danger to life due to electric shock!
► Pull the mains power adapter 9 out of the power socket before cleaning
the appliance.
► Never touch the mains power adapter 9 with wet hands, especially when
plugging it in or unplugging it.
► Always keep the mains power adapter 9 and the cable dry.
CAUTION
Possible damage to the appliance.
► The hair and beard trimmer should never be immersed in water or other
liquids for cleaning, as the appliance is not waterproof. Doing this may
damage live parts (batteries).
► Do not use aggressive or abrasive cleaning agents, as these may corrode
the surface of the casing.
► Clean the housing only with a soft damp cloth and a mild detergent.
♦ Switch the hair and beard trimmer off by pressing the ON/OFF switch 6 .
♦ Disconnect the cable from the appliance and pull the mains power adapter 9
out of the power socket.
♦ Remove any cutting length attachment ( 10 or 11 ) from the appliance.
♦ Wash the cutting length attachment ( 10 or 11 ) under running water if required.
♦ Dry the cutting length attachment ( 10 or 11 ) thoroughly afterwards.
♦ Push the slide switch for the thinner attachment 3 right as far as the stop to posi-
tion 0 to move the thinner attachment 2 into its starting position.
♦ Press your thumb against the front of the cutting unit to release it from its
holder (see Fig. D). Then remove the cutting unit from the appliance.
♦ Use the cleaning brush supplied to remove any residual hair from the cutting
unit
.
♦ Once you have completed cleaning, push the tab of the cutting unit into the
mounting opening on the appliance (see Fig. E).
♦ Push the cutting unit back onto the appliance by pressing lightly from above until
it clicks into place (see Fig. F).
IB_102827_SHBS600A1_LB5.indb 52 23.10.14 12:18