Silvercrest SHBS 600 A1 - Manual (Page 53)

50 SHBS 600 A1
GB
MT
Operation with the mains power adapter
If your hair and beard trimmer stops working during shaving due to a discharged
or weak battery, you can continue shaving by plugging in the mains power
adapter
9 .
♦ Plug the cable plug of the mains power adapter 9 into the socket 8 on the
underside of the hair and beard trimmer.
♦ To avoid injuries and damage to the appliance, always switch the appliance
off before connecting it to the power supply.
♦ Plug the mains power adapter 9 (wide-range voltage 100–240 V) into a
power socket complying with the appliance specifi cations.
♦ After 1–2 seconds, you can switch the appliance on by pressing the ON/OFF
switch
6 . If the appliance does not start immediately, switch it off again and
wait around 1 minute before switching it on again.
Oiling the cutting units
We recommend that you oil the cutting unit before fi rst use and after cleaning
to ensure full mobility.
♦ To do this, simply apply a couple of drops of blade oil (accessory) between the
blades, and then distribute it evenly.
♦ Wipe off any access oil with a soft cloth. Use only non-corrosive oils such as
sewing machine oil.
Handling and operation
Attaching/changing the cutting length attachments
The cutting length attachments 10 and 11 off er settings for 10 diff erent cutting
lengths (4/7/10/13/16/18/21/24/27/30 mm).
♦ Push the respective cutting length attachment ( 10 or 11 ) onto the cutting unit
from above so that the two side rails slot into the provided guides.
♦ Push the cutting length attachment ( 10 or 11 ) down until it snaps into place on
the mounting points 4 .
♦ To remove the cutting length attachment, move the slide switch for cutting length
adjustment
5 upwards (position 5) and then pull the cutting length attachment
( 10 or 11 ) upwards off the appliance.
IB_102827_SHBS600A1_LB5.indb 50 23.10.14 12:18