Silvercrest SRD 250 A2 - Manual (Page 12)

10 SRD 250 A2
GB
Setting up and connecting
The surfaces of furniture may contain components that can aff ect ■
the rubber pads of the appliance and could soften them. If neces-
sary, place a covering under the appliance’s rubber pads.
The mains power socket must be easily accessible so that, in an ■
emergency, the plug can be quickly withdrawn from the socket.
Electrical connection
Before connecting the appliance compare the connection data ■
(Voltage and frequency) on the rating plate with that of the mains
electric source. This data must be compatible to avoid possible
damage to the appliance.
Make sure that the appliance’s connection cable is not damaged ■
and is not laying over hot surfaces and/or sharp edges.
Make sure that the connection cable is not tightly stretched or bent. ■
Do not allow the connection cable to hang over edges ■
(Trip wire eff ect).
Inserting the batteries
By inserting two 1.5 V batteries (type R6/LR6/AA/Mignon) you
avoid losing the programmed time of day and wake time in the
event of mains power loss. The batteries make sure that the internal
clock continues to run even during a power outage.
When power is restored the correct time appears automatically
in the display
2 .
NOTICE
The display, radio and alarm do not function with battery- ►
power alone.
Buch_66666_LB4 indb Abs2 10 15 06 2011 12 06 49 Uhr