Fig.3 fig.4, Fig.5 fig.6 fig.7 – Sealey SPB57T User Manual
Page 2
4.9.
Place the hopper (6) over the frame tube assembly (1) so
that the shaft protruding from the impeller on the frame tube
assembly locates into the swivel bush on the base of the
hopper.
4.10. Align the six bolt holes in the hopper assembly with the six
bolt holes on the frame tube assembly and fit the Hex Bolts
M6x40 (9) with the big flat washers M6 (15) at the bolt heads.
Loosely attach the M6 lock nuts (13) as shown in figure 6.
Adjust the hopper assembly over the frame tube assembly
until the impeller is free to rotate without any resistance. fully
tighten the nuts and bolts securing the hopper assembly to
the frame tube assembly.
4.11. Attach the r-pin (19) to the shaft protruding above the
impeller as shown in figure 7.
4.5. Attach the hitch tube (2) to the frame tube assembly tube (1)
using hex bolt M6x40 (9), big flat washer M6 (15) and M6 lock
nut (13) as shown in figure 3. At this stage do not fully tighten
the nut and bolt.
4.6. Attach one brace (3) to either side of the hitch tube (2)
using hex bolt M6x35 (8) and M6 lock nut (13) as shown in
figure 4. Do not fully tighten the nut at this stage
fig.3
fig.4
4.7. Attach the other ends of the braces (3) to the frame tube assembly
(1) using hex bolt M6x35 (8) and M6 lock nuts (13) as shown in
figure 5.
4.8. All nuts and bolts used for the braces (3) can now be fully
tightened
fig.5
fig.6
fig.7
4.12. Attach a Ø8 flat washer (16) over the loose end of the
adjustable connection rod and insert the rod through the
hole in the fixing plate at the base of the hopper and secure
with a M8 lock nut (14) as shown in figure 8.
4.13. Place the hopper screen (4) into the hopper (6) so that it sits
squarely on the base.
4.14. the spreader is now fully assembled and ready for use.
Original Language Version
sPB57t Issue: 2 (I) - 17/09/13
© Jack sealey Ltd