United Office ULGD 350 A1 - Manual (Page 67)

64 ULGD 350 A1
GB
Preparing for hot lamination
♦ Insert the document support into the two openings under the pouch ejector
slot , such that it is seated fi rmly on the appliance.
♦ Insert the plug of the laminator into a mains power socket.
♦ Switch the appliance on by placing the selector switch for hot and cold
lamination
5 at "HOT". The red indicator light Power 3 glows.
♦ Place the pouch thickness switch 4 at the corresponding pouch thickness
(see also chapter Switching levels).
NOTICE
► The attainment of the operating temperature is indicated by the glowing
of the green indicator light Ready
2 . For a more uniform laminating result
we recommend, especially for thinner foils (below 125 Micron), and after
adjustment to a diff erent foil thickness, to fi rst wait an additional 2-3 minutes
before beginning with lamination.
♦ Place the document to be laminated into a laminating pouch of the
appropriate size.
NOTICE
► Ensure that all edges of the document have at least two millimetres of
space to the edges of the laminating pouch, as shown in Fig. 1.
► Ensure that you use only one pouch for laminating. First open it up, as
shown in Fig. 2.
► For further information about the lamination process, please read the
section Lamination process.
Fig. 1
Fig. 2
IB_91013_ULGD350A1_LB1.indb 64 IB_91013_ULGD350A1_LB1.indb 64 20.06.13 14:41 20.06.13 14:41