Kichler 300001 - Manual (Page 6)

5
Fig. 10
Registration slot
Fig. 9
Step 7. Now lift the motor assembly into
position and place the hanger ball into the
hanger bracket. Rotate until the “Check Tab”
has dropped into the “Registration Slot” and
seats firmly. (Fig. 10)
NOTE: The entire motor assembly should
not rotate if this is done correctly.
NOTE: Please make sure all set screws
are in place and tight before installation
the following steps.
Canopy cover
Downrod
Canopy
Coupling cover
Step 6. Slip the coupling cover, canopy
cover and canopy onto the downrod. Rein-
stall hanger ball into the downrod and make
sure the cross pin is in place and set screw
on hanger ball is tight. Secure the coupling
cover is resting on the top of ceiling fan.
(Fig. 9)