Kichler 300001 - Manual (Page 13)

15. INSTALLING THE CoolTouch™
CONTROL SYSTEM WALL PLATE
To install the coolTouch TM control system wall
plate, you can select the following locations to
fulfill your wall plate installation.
1. Using the existing wall outlet box:
Step 1. Remove the existing wall plate and the
old switch from the wall outlet box. Wire nut the
BLACK leads (hot) together and push back
inside the outlet box. (Fig. 27)
2. Install on flat wall:
Attach the metal plate to outlet box by two (2)
screws. Place the coolTouch TM wall plate on a
flat wall using the wall anchors and 2 wood
screws provided.
3. Install 2,3 volt #2032 battery included with the
coolTouch TM control system.
Note: To prevent damage to transmitter, remove
the batteries if not used for long periods of time
(months). (Fig. 29)
16. INSTALLING THE TRANSMITTER
1. To place the transmitter in the wall plate, put
the bottom end in first and then press the top
into the wall plate. The transmitter is now held
in the wall plate and will function from here.
(Fig. 30)
2. To remove the transmitter from the wall plate,
push the release button and the transmitter will
fall into your hand.
Fig. 27
Fig. 28
Fig. 29
Fig. 30
Release
button
Wal l p l at e
Sw i t c h
Ou t l et b o x
12 Chicago
TM
CoolTouch wall plate
Ou t l et b o x
Metal plate