Kichler 15529 User Manual
Kichler Hardware
STEP 1
• Turn power off.
• Rotate wings fully apart.
KICHLER
®
PRO SERIES WIRE CONNECTOR INSTALLATION INSTRUCTIONS
Always use caution. Turn off power. Use on electrical circuits of 15 volts or less.
Installation should always comply with local and national electrical codes
STEP 2
Using the strip guide molded
into the connector for reference,
strip the wire to 11/16”.
STEP 3
Insert wires into connector.
Connector must be open.
• #12 in large holes
• #18 in small holes
STEP 4
(Optional if testing voltage at fixture)
Turn power back on. With connector still
open halfway, push voltmeter probe into
connector probe port. Push probe all the
way in and repeat on other connector.
STEP 5
Hold wires in place while squeezing
wings together until the connector
snaps shut. Use pliers if necessary
to close. Repeat on other connector.
IS-15529
- 12011 v.2 (1 page)
- 3000 (2 pages)
- 4100 (2 pages)
- 10566 (2 pages)
- 10579 (1 page)
- 10190BK60 (1 page)
- 10570 (1 page)
- 10215 (1 page)
- 12211 (1 page)
- 10198 (1 page)
- 10589 (1 page)
- 9592 (1 page)
- 12068 (4 pages)
- 12501 v.2 (1 page)
- 12353WH v.2 (1 page)
- 12382 (1 page)
- 12382 (2 pages)
- 12383 (1 page)
- 15070 (2 pages)
- 15215 (1 page)
- 4200 (1 page)
- 4900 (1 page)
- 4931 (2 pages)
- 4100 (2 pages)
- 15565 (1 page)
- 15635 (2 pages)
- 15509 (2 pages)
- 15578 (2 pages)
- 15777 (1 page)
- 15635 (2 pages)
- 15635 (2 pages)
- 15635 (2 pages)
- 15635 (2 pages)
- 15635 (2 pages)
- 15635 (2 pages)
- 15635 (2 pages)
- 15635 (2 pages)
- 15635 (2 pages)
- 15688 (2 pages)
- 15717 (2 pages)
- 15511 (1 page)
- 15620 (1 page)
- 15415 (2 pages)
- 15671 (1 page)