Irritrol IBOC-Plus - Manual (Page 15)

13
SETTING PROGRAM START TIME(S)
This procedure is used to set the watering cycle start time(s) for each
program. A maximum of eight start times per program can be assigned.
Each start time will initiate a sequential watering cycle of all stations
with an assigned run time in the program.
Note: It is important to remember that a start time initiates the entire
watering program cycle, not an individual station.
PROGRAM LOOPING
The Program Looping feature enables a watering program to start and
run consecutive repeat cycles until a predetermined stop time is reached.
Each program can have one loop operating cycle assigned in addition to
eight regular start time assignments. If a program loop is not assigned, the
display shows “Loop Strt Off.”
To set program cycle start times and/or program loop time:
1. Turn the function dial to the
PROGRAM CYCLE START TIMES/
LOOPING
position.
2. Select Program
A
,
B
or
C
with the
PROGRAM
button.
3. Use the +/
ON
or –/
OFF
button to adjust the start time hour.
4. Press the
NEXT
button to select the minutes digits.
5. Use the +/
ON
and/or –/
OFF
button to adjust the start time minutes.
Note: To remove a start time, adjust the time to display “Off”
which is located between 11:59 p.m. and 12:00 a.m.
6. Press the
NEXT
button and repeat steps 3 through 5 to assign up to
eight start times for the selected program.
7. Press the
NEXT
button to display “Loop Strt.”
8. Use the +/
ON
and/or –/
OFF
button(s) to adjust the loop time hour.
9. Press the
NEXT
button.
10. Use the +/
ON
and/or –/
OFF
button(s) to adjust the loop time minutes.
11. Press the
NEXT
button to display “Loop Stop” and repeat steps
8 through 10 to set the loop stop time.
12. Repeat steps 2 through 11 for each program as necessary.
13. When finished, return the function dial to
AUTO RUN.
Programming the Controller