iHealth Align - Manual (Page 2)

GET STARTED
• Download the App
Prior to first use, download the free iHealth Gluco-Smart App to your mobile device from the Apple
App Store or Google Play Store. Follow the on-screen instructions to create your iHealth account.
• Access the iHealth Cloud Account
Your iHealth account also gives you access to the free and secure iHealth cloud service. Go to
www.ihealthlabs.com and click “Sign In” for access once your account has been created.
• Scan to Code the Test Strips
Please carefully read and follow the instructions below to avoid getting inaccurate test results and/or
test strip tracking errors:
Connect your mobile device to the Internet and open the Gluco-Smart App. When prompted, scan
the QR code on the top of the iHealth test strip vial to calibrate the test strips with the meter. You
must scan the QR code each time a new vial is opened.
• Test blood glucose level
Step 1: Launch the App
Step 2: Connect the meter
- Plug your meter into the headphone jack of your mobile device. The iHealth logo on the
meter should be facing the same direction as the screen of your mobile device.
Note:
• Do not twist your meter during the measurement process.
• Remove the case on your mobile device before connecting the meter.
Step 3: Insert the test strip into the meter’s strip port
Make sure the red arrow marker on the test strip is facing the same direction as the iHealth
logo on the meter.
3. Insert the new battery with the “+” side facing up and snap it into the battery tray.
4. Press the back panel back in place by inserting the front clip into place and snapping the back of
the cover down.
When the “Battery is low” indicator appears on the app, replace the battery to ensure successful and
accurate measurements.
Disposal – Electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your local authority or retailer for recycling advice.
Your meter comes with two 3V CR1620 lithium battery. The battery lasts up to six months depending
on the usage. Follow the instructions below to replace the battery.
1. Turn the meter over with the iHealth logo facing down.
2. Lift off the back cover by pulling firmly from the notch next to the test strip port.