H3C Technologies H3C S5800 Series Switches - Manual (Page 19)

15
Figure 7 Install the rear mounting brackets to the rack
(1) Rear square-holed posts of the rack
(2) Rear mounting bracket
5. With one hand supporting the bottom and the other hand holding
the front end of the RPS1600-A, gently push the RPS1600-A into
the rack. After pushing the RPS1600-A into the rack, make sure of
the close contact between the upper edges of the rear mounting
brackets on the rack and the weight-bearing screws on the
RPS1600-A, as shown in
Figure 8 .
6. Fix the front mounting brackets to the front square-holed posts of
the rack by using M6 screws and cage nuts (user supplied). Make
sure that the RPS1600-A is securely fixed with the front and rear
mounting brackets on the rack, as shown in
Figure 8 .