H3C Technologies H3C S5800 Series Switches User Manual
Page 17
13
Install the RPS1600-A by using front and rear mounting
brackets
Follow these steps to install the RPS1600-A by using front and rear
mounting brackets:
1.
Wear an ESD-preventive wrist strap (make sure it makes good skin
contact and is well grounded), and check the grounding and
stableness of the rack.
2.
Unpack the supplied front mounting brackets and screws, and
attach the front mounting brackets to the RPS1600-A with the
screws.
shows how to install a mounting bracket to one
side of the switch. Install the other mounting bracket in the same
way.
Figure 5 Install a front mounting bracket to the RPS1600-A
(1) Front panel of the RPS1600-A
3.
Unpack the supplied weight-bearing screws and install them into
the appropriate screw holes at both side of the RPS1600-A.
(1)