ARM Electronics MP13DVPDN - Manual (Page 14)

13
Step 10:
Attach the snap-on module into the
Dome Camera housing.
NOTE:
The terminal blocks
should face the side conduit
entry, as shown in the figure.
Step 11:
Connect the power and network outputs.
Step 12:
After the Dome Camera body is mounted and the cables are connected.
Adjust the camera to a desired angle, as shown below. Pan adjustment
range is nearly 360°; rotation angle range approaches to 300°. Tilt is
adjustable between ﹣10° ~ 90°.
Pan Adjustment Rotation Adjustment Tilt Adjustment
NOTE:
Adjust the lens carefully within the limits mentioned above, or
the cables underneath would be harmed.