Archgard 25-BVI20N-2 - Manual (Page 33)

25-BVI20N –2 33
1. Unhook the screen rod at the center and remove screens or glass door.
2. Unscrew and remove the front trim strip at the front of the firebox bottom.
3. Remove the burner/sandpan assembly, valve and pilot assembly from the firebox bottom
plate. Leave the plate in place to support the gas insert.
4. Bend the front deflector plate forward and up. Measure the height of the front opening. The
opening must be 15 ¼” of higher.
5. The preparation of the host gas fireplace is complete. See Appendix A of the Euro-25
manual for further instructions. All installation requirements in the manual must also be
carefully observed and followed.
6. Use Archgard 25-ICKIT5 connector kit to connect the insert to the host’s B-vent or connect
a 4” diameter flexible aluminum gas vent from the insert to the host’s vent cap.
ITEM 2.
REMOVE
ITEM 4.
TO
BEND 15 ¼”
INSTALLATION INSTRUCTIONS
INSTALLING THE EURO 25 GAS FIREPLACE INSERT HEATING APPLIANCE
INTO VENTED ZERO-CLEARANCE GAS FIREPLACE:
FIREHEARTH / MONTEREY MODEL FIRESONG 220 SERIES
CAUTION: Installation must be conducted by a qualified gas appliance installer. Gas and
electrical power must be disconnected from the host gas fireplace before
installation can begin.