MovinCool CMW30 - Manual (Page 19)

19
INSTALLATION (cont.)
Drain Hose Connection (cont.)
4. Check the following items.
• No kinks or bends on the drain hose
• No trap in the drain hose
• The end of the drain hose should be higher than the water level at the drain
• No dripping from the drain hose at the clamping area
• When uninstalling the unit, empty the drain pan by draining out the water
through the condensate pan drain pipe.
For the gravitational drain, power connection to the internal condensation removal
pump must be disconnected. Follow the procedures shown below.
CAUTION: The condensate water will drain out from the drain pipe
of the condensate pan if the internal condensation removal pump
connector is not disconnected.
1. Disconnect power.
2. Remove five (5) screws from the top
panel.
UNIT
SLOPE
ABOVE
DRAIN
WATER
NO TRAP
TO DRAIN HOSE
UNIT
NO TRAP
NO POOL
ILL00267-00
SCREWS (5)
TOP PANEL
ILL00344-00