Microsens MS400934 - Manual (Page 8)

6
Technical Specifications
The following table provides the technical specification of the Power over
Ethernet Injector.
Standard
IEEE802.3 10BASE-T
IEEE802.3u 100BASE-TX
IEEE802.3ab 1000Base-T
IEEE802.3at Power over Ethernet
Connector
10/100/1000 Mbps:
Data in: 1 x RJ-45 Data pin 1, 2, 3, 6, 4, 5, 7, 8
Data & Power out: 1 x RJ-45
Data pin 1, 2, 3, 6, 4, 5, 7, 8
Power pin 1, 2, 3, 6
Network Cable
10BASE-T: 2-pair UTP/STP Cat.3, 4,5 cable
EIA/TIA-568 100-ohm (100m)
100BASE-TX: 2-pair UTP/STP Cat.5 cable
(Cat. 5e recommended)
EIA/TIA-568 100-ohm (100m)
1000Base-T: 4-pair UTP/STP Cat. 5e or above
cable
EIA/TIA-568 100-ohm (100m)
LED
AC Power
Feeding power
Power Input
AC Input Voltage Range : 100 ~ 240V
AC
50 ~ 60 Hz, 0.72A
Power Output [email protected]
Operating
Temperature
0
o
C ~ 40
o
C
Operating 10% ~ 90% Humidity (non-condensing)